Hệ thống nhân tín hiệu hình cho khoảng cách xa chuẩn 4K (HDMI to Four Output DTP DA - 100 m)

Video
   Maximum data rate     10.2 Gbps (3.4 Gbps per color)
   Maximum pixel clock    300 MHz
   Resolution range         Up to 2560x1600* @ 60 Hz or 4K (4096x2160) @ 30 Hz. UHD (3840x2160) @ 30 Hz.
4K/UHD @ 60 Hz with 4:2:0 chroma subsampling
(*Reduced blanking)
   Color bit depth            8. 10. or 12 bits — subject to the maximum data rate limit
   Formats         RGB and YCbCr digital video
   Standards       DVI 1.0. HDMI 1.4. HDCP 1.4. CEA-861E
Video input
    NOTE            *Appropriate HDMI to DVI-D cables or adapters are required for HDMI signal input/output.
   Number/signal type     1 single link HDMI (or DVI-D*)
   Connectors     1 female HDMI type A
Video output
   Number/signal type     1 single link HDMI (Local Output)
       Connectors
      DTP HD DA4 4K 330  4 female RJ-45
       Termination standards         TIA/EIA T568B
   Signal transmission distance
      DTP HD DA4 4K 330
         1080p @ 60 Hz     Up to 330 (100 m) using shielded twisted pair (STP) cable or XTP DTP 24 cable
         2560x1600 @ 60 Hz           Up to 330 (100 m) using STP cable or XTP DTP 24 cable
         4K/UHD @ 30 and 60 Hz     Up to 330 (100 m) using STP cable or XTP DTP 24 cable
   Cable requirements     Solid conductor. 24 AWG or better
   Cable recommendations           400 MHz bandwidth STP cable
    NOTE            Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance.
    NOTE

Output mode signaling:

DTP:            HDMI with embedded audio. analog audio. RS-232 and IR. and remote power
HDBaseT:    HDMI with embedded audio plus RS-232 and IR
Audio (analog audio)
   Gain   Unbalanced output (from receiver): 0 dB; balanced output (from receiver): +6 dB
   Frequency response    20 Hz to 20 kHz. ±1 dB
   THD + Noise   0.03% @ 1 kHz; 0.3% @ 20 kHz at nominal level
   S/N    >90 dB at maximum input (unweighted)
   Stereo channel separation        >80 dB
   Digital sampling rate    48 kHz
   Bit depth         16 bit
Audio input (analog audio)
   Number/signal type     1 PC level stereo. unbalanced
    NOTE            Analog audio is not embedded onto the digital video signal. Analog audio and digital embedded audio are transmitted simultaneously and output on the receiver on two different connectors.
   Connectors     (1) 3.5 mm stereo jack. 2 channel; tip (L); ring (R); sleeve (ground)
   Impedance     >10k ohms. DC coupled
   Nominal level  -10 dBV (316 mVrms)
   Maximum level            +7 dBV. unbalanced
    NOTE            0 dBu = 0.775 Vrms. 0 dBV = 1 Vrms. 0 dBV ≈ 2 dBu
Audio output
   Number/signal type
      Local output             1 PC level stereo. unbalanced
      DTP output  4 or 8 embedded digital audio on DTP signal
      Embedded digital audio source formats          2-ch PCM. PCM. Dolby Digital 2/0. Dolby Digital 2/0 Surround. Dolby Digital 5.1.
Dolby Digital EX. DTS Digital Surround 5.1. DTS-ES Matrix 6.1
DTS-ES Discrete 6.1
      Connectors
         Local        (1) 3.5 mm stereo jack. 2 channel; tip (L). ring (R). sleeve (ground)
         DTP         4 or 8 female RJ-45
      Impedance  >50 ohms. DC coupled
      Nominal level           -10 dBV (316 mVrms)
      Maximum level         +6.5 dBV (unbalanced)
Control/remote
   Serial control port       RS-232. 3.5 mm. 3 pole captive screw connector
   Baud rate and protocol             9600 baud rate. 8 data bits. 1 stop bit. non-parity
   Serial control pin configurations            Captive screw connectors: 1 = Tx. 2 = Rx. 3 = Gnd
   USB control ports        1 front panel female mini USB B
   USB standards            USB 2.0. low speed
   Ethernet data rate       10/100Base-T. half/full duplex. with autodetect
   Ethernet protocol         ARP. ICMP (ping). IP. TCP. DHCP. HTTP. Telnet. SMTP
   Program control          Extrons Simple Instruction Set (SIS™). Extron Product Configuration Software (PCS). Microsoft Internet Explorer. Telnet
Communications — external device (RS-232/IR over TP)
   Serial control port       RS-232 via (4) or (8) 3.5 mm. 5 pole captive screw connectors
(connectors are shared with IR control ports)
   Baud rate and protocol             300 to 115200 baud. 8 or 7 data bits. 1 or 2 stop bits. non-parity (default). even or odd parity
   Serial control pin configuration             Captive screw connectors: 1 = Tx. 2 = Rx. 3 = Gnd
   IR pass-through control port     (4) or (8) 3.5 mm. 5 pole captive screw connectors (connectors are shared with RS-232 control ports)
TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz
   IR control pin configuration       3 = Gnd. 4 = IR Tx. 5 = IR Rx
   General
   Power supply  Internal
Input: 100-240 VAC. 50-60 Hz
   Power consumption
      DTP HD DA4 4K 330  46.3 watts
      Temperature/humidity          Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%. noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%. noncondensing
   Cooling           Convection. with vents
   Thermal dissipation
      DTP HD DA4 4K 330  87.8 BTU/hr
   Rack mount    Yes. with included rack ears
   Enclosure type            Metal
   Enclosure dimensions
      DTP HD DA4 4K 330  1.75" H x 17.5" W x 10.6" D (1U high. full rack wide)
(4.4 cm H x 44.4 cm W x 26.8 cm D. depth excludes connectors)
       Vibration    ISTA 1A in carton (International Safe Transit Association)
   Regulatory compliance
      Safety         CE. c-UL. UL
      EMI/EMC     CE**. C-tick. FCC Class A**. ICES. VCCI