Two Channel Low and High Impedance Amplifiers – 100 Watts Per Ch @ 8 Ohms

Audio
  - Voltage gain : 23x (27dB)
  - Stereo channel separation: >75 dB @ 1 kHz
  - CMRR: 75 dB @ 1 kHz (typical)
Audio input
  - Number/signal type: 1 stereo or 2 mono. balanced/unbalanced
  - Connectors: (1) 3.5 mm captive screw connector. 5 pole
  - Impedance: >10k ohms unbalanced/balanced. DC coupled
  - Nominal level: +4 dBu (1.23 Vrms). balanced
  - Maximum level: +20 dBu (7.75 Vrms). balanced
  - Input sensitivity
          + 8 ohm or higher speaker load: +4 dBu (1.23 Vrms)
          + 4 ohm speaker load: +1 dBu (0.87 Vrms)
  - Input signal detection threshold: -40 dBu ±3 dB. balanced
Audio output:
  - Number/signal type: 1 stereo. 4 or 8 ohm direct
  - Connectors: (1) 5 mm screw lock captive screw connector. 4 pole
    NOTE: These connectors accept wires of 22 AWG to 12 AWG.
  - Load impedance: 4 ohms minimum
  - Amplifier type: Class D
 Output power
  - 100 watts rms per channel. 8 ohms. 1 kHz. <0.05% THD
  - 100 watts rms per channel. 4 ohms. 1 kHz. <0.05% THD
 Frequency response: 20 Hz to 20 kHz. ±1 dB
   THD + Noise: 0.05% @ 20 Hz - 20 kHz. 8 ohms. at 3 dB below clipping
   S/N: 105 dB. 20 Hz - 20 kHz. unweighted
   Damping factor: >100 @ 8 ohms